Router Forums banner
1 - 2 of 24 Posts

· Registered
Mike
Joined
·
3,960 Posts
another option; on the profile toolpath, go down to profile options "ramps/leads/order/start at/corner", select corner. in that window you can select square inside corners and square outside corners for that profile.
Using this way you will still need to create the 2 vectors for the pocket toolpath to clear the waste material between the chamfers(profile toolpath). You can do away with the V-Carve toolpath.
 
1 - 2 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top