Router Forums banner
1 - 2 of 2 Posts

· Registered
62 Posts
Discussion Starter · #1 ·
Hi all

Making a better base for a work bench, using 6x6's for the corner legs.
In using the band saw, I guess I fed the lumber a bit too fast, leaving a belly on the top of the post. Don't have a ski setup yet for the plunge router, but figure I'd just build a box around the top of the lumber and run the router across, squaring the top.
Has anyone done the same with success??
Or have a better suggestion ????
Thanks !!!!!!

· Retired Moderator
16,386 Posts
Yes. I flattened the top of my laminated work bench that way. Made a giant sled and slid it across the edges of sheets of mdf on either side of the bench.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.