One of the members has just obtained a very old Stanley router.
I believe the base model is GA-H279A? not sure of the motor model number.
He is looking for a manual for that router, probably in the same file a Hens Teeth.
I helped him with the edge guide, but cannot seem to find any pin/lock to enable the collet to be undone to replace the cutter.
It only has a very old round over cutter with a fixed bearing.
Any help from the forum?
I believe the base model is GA-H279A? not sure of the motor model number.
He is looking for a manual for that router, probably in the same file a Hens Teeth.
I helped him with the edge guide, but cannot seem to find any pin/lock to enable the collet to be undone to replace the cutter.
It only has a very old round over cutter with a fixed bearing.
Any help from the forum?
