Router Forums banner
1 - 1 of 1 Posts

·
Registered
Mike
Joined
·
3,960 Posts
You should try re-calculating the toolpath and re-save the new cut file. Make sure you are using the VCarve toolpath and that you are starting the cut at 0.00. If you start deeper the stars will be larger and have round corners.

It might also be the bit. The way most v-bits are made the point is not really pointed but actually has a flat tip. Some of them have a pretty good size flat tip. For perfectly sharp corners on things like stars, a three flute bit like this is needed.

 
  • Like
Reactions: TimPa
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top