Router Forums banner

Stepper Motor Cables and Adapters

1162 Views 10 Replies 9 Participants Last post by  radio_davio
3
Hello, I have a 4'x4' cnc router I bought from a company called Velox a few years back and I had a stepper motor cables burn out that I'm looking to replace but the company no longer exists and I haven't had any luck finding the correct replacement. They are about an inch wide. Please help, thank you
Hand Arm Guitar accessory Musical instrument Finger

Finger Thumb Nail Terrestrial plant Wrist

Automotive tire Finger Motor vehicle Tire Thumb
See less See more
1 - 11 of 11 Posts
I would just find another readily available 4-pin connector and switch to that rather than be down.
  • Like
Reactions: 1
I would just find another readily available 4-pin connector and switch to that rather than be down.
Hey David, thanks for responding. Do you know where I can order these connectors?
Amazon has plenty from which to choose or you can go to a site that has very specific choices, like this one - Mouser Electronics
  • Like
Reactions: 1
Welcome to the forum.
Hello, I have a 4'x4' cnc router I bought from a company called Velox a few years back and I had a stepper motor cables burn out that I'm looking to replace but the company no longer exists and I haven't had any luck finding the correct replacement. They are about an inch wide. Please help, thank you View attachment 400926
View attachment 400925
View attachment 400924
Check DigiKey. They may have the identical connector. If not, they should have a similar 4 prong connector.
Hello, I have a 4'x4' cnc router I bought from a company called Velox a few years back and I had a stepper motor cables burn out that I'm looking to replace but the company no longer exists and I haven't had any luck finding the correct replacement. They are about an inch wide. Please help, thank you View attachment 400926
View attachment 400925
View attachment 400924
I would check with Corvetteguy50 cnc I'm sure he would have what you need or can steer you in the right direction. He builds and sells controllers.
Check with an electrical supply house, give them the voltages you'll be running through the wires and they get you the proper Molex connector. Most Stepper drivers are are around 9-48 volts.
Hello, I have a 4'x4' cnc router I bought from a company called Velox a few years back and I had a stepper motor cables burn out that I'm looking to replace but the company no longer exists and I haven't had any luck finding the correct replacement. They are about an inch wide. Please help, thank you View attachment 400926
View attachment 400925
View attachment 400924
Check with an electrical supply house, give them the voltages you'll be running through the wires and they get you the proper Molex connector. Most Stepper drivers are are around 9-48 volts.
buildyourcnc.com has everything you need
Hey David, thanks for responding. Do you know where I can order these connectors?
I order a lot of stuff like this from Mouser and also Digikey.
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top