Router Forums banner

Swivel Stool Episode

2102 Views 1 Reply 2 Participants Last post by  BobandRick
BobandRick,
I watched the episode again yesterday, and have a question. It was clear on drilling the dowel holes on an angle due to the legs being angled, but I did not see where that angle was considered for the sliding dovetail joint, aprons to legs.
Could you expalin how to jig that cut, please?
Many thanks,
ken
1 - 2 of 2 Posts
Ken Massingale said:
BobandRick,
I watched the episode again yesterday, and have a question. It was clear on drilling the dowel holes on an angle due to the legs being angled, but I did not see where that angle was considered for the sliding dovetail joint, aprons to legs.
Could you expalin how to jig that cut, please?
Many thanks,
ken
The short answer is 5 degrees and I think we pre-cut the pieces with a miter saw. Having said that I now have to confirm the answer by looking at the tapes, so many different projects already completed in front of the stools. Get back to you in a couple of days...
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top