Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
BobandRick,
I watched the episode again yesterday, and have a question. It was clear on drilling the dowel holes on an angle due to the legs being angled, but I did not see where that angle was considered for the sliding dovetail joint, aprons to legs.
Could you expalin how to jig that cut, please?
Many thanks,
ken
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top