Router Forums banner
1 - 6 of 6 Posts

· Official Greeter
Joined
·
20,392 Posts
G'day Tayo, welcome to the forum,

Where do you want to use the T-nuts?
 

· Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
*on cnc table enduro tekcel
*the reason need to use T nuts, is to hold down on vacuum table of enduro cnc, caused sometimes the material not really flat, although the vacuum on table already sucked maximum
*I need information beside to use T nuts, what kind another tools can use ?
 

· Official Greeter
Joined
·
20,392 Posts
I understand you want to put T-nuts in the work table to use hold downs on the work material?

I do not use CNC, but don't see any problem as long as you never cut all the way through the material....You would have to avoid the T-nuts, bolts and clamps in some way..

Someone with more CNC experience may be able to help.
 

· Registered
Joined
·
1,351 Posts
T-nuts might pull out if pressed into the top of the bed. You'll loose the vacuum suction if you press them into the bottom. Threaded inserts can be screwed into the top surface and if the bed is thick enough don't have to be in a through-hole.
4D
 
1 - 6 of 6 Posts
Top