Router Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a Craftsman router model 315.268350 and would like to mount it to a table. I was able to pick up a BOSCH RA1181 Benchtop Router Table rather inexpensively but the two are not compatible. Any ideas if the router can be mounted to this table?
Thank you.
 

·
Registered
Joined
·
219 Posts
Randy,
Welcome to the forum. There is a lot a good information here, so once you get your table set up, let us know how it goes and show us some of your projects.

You could re-drill the mounting plate in that table to except your router. Just be sure it is centered before you drill the holes. If the router plate on that table excepts bushings, you could use a bushing and a centering bit to get the router centered before you drill the holes. Below is a link that may help you out.

http://www.routerforums.com/table-mounted-routing/14985-centering-your-router-mounting-plate.html

Darrin
 
1 - 2 of 2 Posts
Top