Router Forums banner
1 - 1 of 4 Posts

· Registered
3,765 Posts
Welcome to the forum. I would suggest making your own plate but that would entail drilling holes If you remove the base plate from your Black and Decker Router just center it on a Router insert plate that fits your table and drill and countersink the mounting holes. i attached the a link to your model so others would know what it is. 1200W 6.35mm Plunge Router
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.