Joined
·
159 Posts
I am looking for a very precise table raise mechanism. Any suggestions?
table recomendations
1 - 8 of 8 Posts
Joined
·
31,264 Posts
raise a table or the router...
for a router lift....
JessEm lifts...
W/ JessEm 1/128th'' is easy...
1/256'' takes a little practice..
Joined
·
159 Posts
thanks
Do you know the difference between the master and Rout R? It is not obvious on the site.
Scott
Do you know the difference between the master and Rout R? It is not obvious on the site.
Scott
Joined
·
1,589 Posts
Mast-R Lift II takes larger routers, I believe.
They are all about the same precision. But since they all use a similar screw style lift control, the only precision that matters is your ability to precisely measure the bit height.
If you are going get the Mast-R Lift II, buy the Incra version. Better support and it comes with the Magna Lock plates that don't require a special tool. Also, you can get the clean sweep plates for much better dust collection.
They are all about the same precision. But since they all use a similar screw style lift control, the only precision that matters is your ability to precisely measure the bit height.
If you are going get the Mast-R Lift II, buy the Incra version. Better support and it comes with the Magna Lock plates that don't require a special tool. Also, you can get the clean sweep plates for much better dust collection.
Joined
·
31,264 Posts
medium size motors for the Rout R and the master takes any motor you can find...
JessEm builds Incra lifts...
I have the JessEm..
support (CS/TS) is better than next generation outstanding...
Hello Scott.
About 4 months ago I acquired a Woodpeckers PRL V2 lift. I must say it is quite the sweet lift. Raises and lowers like a dream and precisely adjustable. It is probably the priciest lift on the market, but the shock only lasts until you first use it.
I bought mine with the Porter Cable 7518 motor.
Sent from my iPad using Tapatalk
Joined
·
21,703 Posts
Also consider getting a Triton TRA001 3.5hp router. It has a built in lift,is about $280, about the cost of a lift. I had a Rockler lift, but didn't like it much. It is a bit heavy for hand held use, at least to my, but it excels in the table. It has power to spare.
Joined
·
508 Posts
I second this motion - am using the Rout-R-Lift II with a Bosch 1617 router in Bosch table - had to trim the phenolic 1/16” all around. Sweet...
Attachments
1 - 8 of 8 Posts
Join the discussion
