Router Forums banner

Table saw blade guard?

2302 Views 1 Reply 2 Participants Last post by  Joe Lyddon
I removed the blade guard/splitter from my JET because I find I use my cross-cut sled so often. But I am very nervous about using the saw without a guard/splitter. Last time I looked at an aftermarket piece they were all absurdly expensive (for what they were) and I lost interest.
Any ideas. It has to be something I can pop in and out in a easonable amount of time. Thank you.
1 - 2 of 2 Posts
Birch said:
I removed the blade guard/splitter from my JET because I find I use my cross-cut sled so often. But I am very nervous about using the saw without a guard/splitter. Last time I looked at an aftermarket piece they were all absurdly expensive (for what they were) and I lost interest.
Any ideas. It has to be something I can pop in and out in a easonable amount of time. Thank you.
If you can get it, this may help...
http://www.taunton.com/finewoodworking/ToolGuide/ToolGuidePDF.aspx?id=2752

http://www.taunton.com/finewoodworking/SkillsAndTechniques/SkillsAndTechniquesPDF.aspx?id=2269
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top