Router Forums banner
1 - 1 of 6 Posts

· Premium Member
508 Posts
ShaneB said:
I have a 10" Craftsman Table Saw with the original blade on it. I rarely use it due to it being difficult to get square cuts and the cuts are a little rough. Should I be looking at getting a new blade? If so, what kind? What does the number of teeth have to do with the type of work/cuts? Thanks!
Hello Shane,

You might also check to see if your fence is square, the Craftsman that I got from my dad and the one my brother owns has twisted fences. Not sure how this happens but my brother was able to take the twist out of his. They are both older saws.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.