Router Forums banner
1 - 2 of 6 Posts

· Registered
36 Posts
Discussion Starter · #1 ·
I have a 10" Craftsman Table Saw with the original blade on it. I rarely use it due to it being difficult to get square cuts and the cuts are a little rough. Should I be looking at getting a new blade? If so, what kind? What does the number of teeth have to do with the type of work/cuts? Thanks!
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.