Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
922 Posts
Discussion Starter · #1 ·
I'm checking my table saw blade alignment. Instead of doing the alignment with a saw blade I am thinking that a piece of 1/2" MDF might make a good alignment plate....should be dead flat. Your thoughts?
 

·
Registered
Joined
·
922 Posts
Discussion Starter · #4 ·
There is room for blade stiffeners. Not enough room for saw blade(s). It's a contractor saw and I have PALS to help with the alignment and I have a plunger dial indicator and I've been able to get it very accurate in the past.
I usually install a premium blade for accuracy....should be interesting how the MDF will work out.
I'll let you know.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top