Router Forums banner
1 - 1 of 49 Posts

· Registered
6 Posts
I am using guide bushings on my Ryobi router with a straight bit and not a flush trim bit. I find that the thickness of wood I can do is 0.75 inches since the cutting length on my router bits are 0.75 inches. Even at 1/8 inch per pass the max material thickness I can route is 3/4 inches. If I try to increase it then the amount of router bit in the collet will be lesser and can cause instability. Ideal I wanted to use template routing on thicker workpieces like a 2x6 for chair legs etc. How do I get around this limitation? Also can someone share some links to how I can use template guide bushings to create curved chain legs or profiles? Sent from my GM1917 using Tapatalk
Not sure if this will help but I once needed a deeper cut with a guide bushing that I couldn’t achieve so I cut the guide bushing down and it worked great.
1 - 1 of 49 Posts