Router Forums banner
1 - 1 of 24 Posts

· Registered
8,958 Posts
If you clamp a short straightedge on the top of your board to let the base of the router cut square to your board. Set the bit to the correct depth and proceed to take small cuts til the base of the router makes contact with the straight edge and make the final pass. Something like the first video but he doesn't use a straight edge to make his final cut.
Then tun the board over and repeat.

1 - 1 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.