[jwilly8311]

Huanyang inverter model HY02D223B
Having issues with Spindle not reaching full RPM of 24000. Topping at 19200. Backstory here is I probably screwed something up in the wiring after switching my 2 spindles doing some troubleshooting. Before that I didn't have this issue. Any help or guidance is very much appreciated. 🍻

 

[jwilly8311]

Video of some damage.

Edit I can't figure how to compress file down🤡​

 

[jwilly8311]

Video preference is widescreen/landscape (not vertical/portrait), post it to YouTube and then you can share the link.

Thank you, sir. A insert famous photographer because I don't know any, I am not.

 

[jwilly8311]

Just use your phone to video and post it to YouTube from your phone.

Thank you. I owe you a beer, sir.

whaaaat?

youtube.com

 

[jwilly8311]

Normal circumstances, and still now for most part I'm using software. Motion Force 19.10.0. I'm messing with the parameters manually. Lot of trial and error. Pretty dadgum neat though.

I'm 95 percent certain they are correct. I've gone back 3 times make sure. Rewired once. Just funny thus issue popped up after I messed with it.🤯

 

[jwilly8311]

Normal circumstances, and still now for most part I'm using software. Motion Force 19.10.0. I'm messing with the parameters manually. Lot of trial and error. Pretty dadgum neat though.

I'm 95 percent certain they are correct. I've gone back 3 times make sure. Rewired once. Just funny thus issue popped up after I messed with it.🤯

@reuelt

 

[jwilly8311]

Also I have the manual to do the factory reset, I believe. What happens after that? Like the MIB photon thing?

 

[jwilly8311]

You've got one or two of the settings wrong in the VFD. You have R, S, T for the 220V, and U, V, W, for the spindle itself plus grd. So if the spindle is working properly on/off, plus correct direction then everything is wired correctly. If you do a RESET then you'll have to re-program the VFD from the beginning.

I got me new spindles in today. I have to replace 1 minimum. I'll go through settings again 1x1. Thanks.