Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi - I am a novice woodworker with a limited budget for my hobby -
I have just been given a 15 amp 2.5 HP plunge router the collet is 1/4, 1/2 and 3/4 - it weighs about 12-13 lbs - It has a speed of 23,000 RPM

What bits should I get for it and is it advisable to mount it to a table

I have never owned a router before - do you have any suggestions on learning to use it other then just practicing with it

Would using a rheostat to slow it down harm it

thank you for any help :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top