Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Those of you who have the Oak Park Panel System: Have anyone used other cutting bits to cut rails & stiles other than what Oak Park sells? I’m very interested in the system but looking for other bits that could be used. What I have found checked with Oak Park and there cutter mesures 1-11/16” in diameter; I have a cutter, which measure 1-3/4” in diameter.

Would a 16th of inch over or under make that much different?

Mossy Oak :confused:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top