Router Forums banner
1 - 1 of 5 Posts

· The Router Guys
Joined
·
791 Posts
Julie said:
Well, I can't pop mine out to change bits. Have to bend down and do it under the table. On the show they pull it up and out and lay it on the table.
(Oh dear, I just re read that and better stop before I get in trouble!)

~Julie~
The base plate has curved edges, which allows you the ability to change the fit as needed. Just sand the edges slightly, testing the fit as you sand...we want the fit to be snug but still easy to remove when changing the router bits. The base will work into the table with use and once you have the base worked in you will see that the table will be much easier and more fun to use.
 
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top