Router Forums banner
1 - 1 of 1 Posts

·
Retired Moderator
Joined
·
16,386 Posts
Good to know about. I was reading on Whiteside's site I think it was that they suggested if you could to go to a larger diameter pattern bit than the 3/4" by 1/2" shank. They said that the bearing on that bit was quite a bit more fragile because of it's size. I wonder if the same is true of these?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top