Router Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
i built my cnc from plans,bought breakout board,motor drivers,stepper motors from Probotix. i got my software from Bobcam ,Bobcamv24. i loaded a program it loaded the G codes the machine worked wounderful until it got to G-code line 500 and stopped. tryed another and it stopped on line 500 . does anyone have any help for me.Bobcam tech support is to expensive for a home hobbie .thanks alot for anyone that can help me
 

·
Registered
Joined
·
101 Posts
I don't know Bobcam but does it generate g-code for Mach3 to drive the CNC controller?

If so, your problem could be that you don't have a valid Mach3 license which limits you to 500 hundred lines of g-code.
 

·
Registered
Joined
·
23 Posts
Hi, I agree; my Bob Cam is a way TOO expensive.

I think your problem with line 500 is you're running in demo mode. You have to buy V24 to run further. If you paid for their over priced software phone their toll free number for help.
 
1 - 3 of 3 Posts
Top