[dutchman 46]

Hi Mile! Welcome. I see that You come from a Dutch area? I made one that was featured in Shop Notes Magazine about a year ago. Ir You would like to build a system that uses Your drill press for power, You can change Your speed to sand as You like. I use wet and dry paper with a little water, or oil. The platters are made out of oriented strand, and I put a 1/4 in. tempered hardboard for the sanding plater. I glued the temp hardboard after cutting the osb board as smooth, and as flat as possible as it was spinning on the platen. So it is pretty flat. Sandpaper from 320, to 1500, in a 4X8 sheet. Now, the speed is Your choice! I think it works nice, but then, it's the only one I have used.