Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
404 Posts
Is there a way or supplier of a touch probe to expedite the programming of shapes in CAM. Example: If I wanted to copy the interior dimension of a bowl, can I do this will a probe and send data back to Fusion?

Thank you
In Mach3 there is a Wizard utility called COPYCAT using a webcam to do that.
I bought the wizards add-on so I cannot say whether you need license to use it or not. But the wizard add-on for Mach3 is cheap.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top