Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I bought a new Triton TRA001 router here in Sweden and mounted it into my table, as pretty much everyone else the screws were too short. I searched around and found out it 1/4-20 UNC so I ordered them and they don’t fit!!

The thread pitch looks very similar but the OD of the ones in the router is 6mm vs 6.35 for the 1/4 screws I got, the thread looks too coarse compared to other 6mm screws I have on hand, any ideas?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top