tracing and digitizing an old diagram for plasma cut

865 Views 2 Replies 2 Participants Last post by woodman12, Feb 13, 2019

Discussion Starter · Feb 10, 2019

using the high accuracy drawing board vi to trace out and digitize
an old diagram for a plasma cut

plasma cut of a horse and plough
this turned out very well!!

Reactions: 4

1 - 3 of 3 Posts

That's very nice, Stan. Might look nice mounted on a plaque too.

Discussion Starter · #3 · Feb 13, 2019

I was born in sask Canada on a farm so this means a lot to me

Reactions: 1

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.