Router Forums banner
1 - 1 of 20 Posts

· Registered
7 Posts
I arrived here because of problem with the TRA001 spindle lock. Different angle on this. Using a router table (Incra) couldn't wind the router up enough to get the spindle lock to engage. Checked the switch was off and the cover extended (about 100 times). Finally took the router out of the table, and found that the black cap over the chamber where the spring used to be was packed with sawdust which was stopping the router being depressed to it's maximum extent. Cleaned this out and all is well.
1 - 1 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.