Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Hi Steve - Someone else was looking for such a bit some months ago. I think they found one, StewMac(sp?) maybe? I think it was 1/8 shank though. Problem is if you have a shank mounted bearing that needs the same ID as the cutting diameter, you haven't got much left for and OD, zero to be exact. I don't know anything about routing guitar bodies but maybe a different template?
Yes it is StewMac, not sure if they have the bit needed but I know the do sell some bits specifically used in guitar construction.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top