Router Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I will be making some Oak boxes with mitered corners. I want to add some splines on the corners. I will be using a sled on my router table to cut the 1/8" or 3/16" groves. I am thinking that a spiral up cut bit would be best for this application...am I correct?
 

· Registered
Joined
·
9 Posts
Discussion Starter · #4 ·
They will be on the outside corner, I have a jig for my table saw now so I guess that I need to purchase a flat tooth blade. I wanted to make some the splines 3/16" I assume that I have to run them thru the saw twice.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top