Router Forums banner
1 - 2 of 12 Posts

· Registered
Joined
·
5,299 Posts
Discussion Starter · #1 ·
I have never used a spiral bit but want to purchase 2 of in the near future. I noticed Infinity Cutting Tools advertising a set of 2 upcuts especially for using on plywood but was wondering if upcuts are suitable for rt use.I know this was discussed previously but I can't find it.,Much obliged for any assistance. Jamesjj777746
 
1 - 2 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top