Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,608 Posts
Sorry, I'm a bit late to this party but I went through a similar exercise about 6 years ago. It was frustrating because there was little information on the compatibility question. Even the opening sizes were hard to find. Some would sell you a template and conveniently forget to say the dimensions and corner radius. I suspected it was a sneaky way to enhance revenue. After a fair amount of digging, there seemed to be two standard opening sizes - Rockler's and everyone else's. If the basic L and W are the same, the corners will probably have the same radius. I don't know if much has changed in the mean time. Good luck and post back what you've found so others don't have to go through what we had to. (I believe I posted about this a while back)
 
1 - 1 of 1 Posts
Top