Router Forums banner
1 - 1 of 7 Posts

· Registered
3 Posts
kp91 said:
Please check speed ratings on any bit, cutter or end mill you might chuck up in your router. Remember, most milling machines are designed with speeds under 5000 rpm, where routers run 10-20,000 rpm. I'd hate to hear about anyone hurting themselves to save $10.
Safety is number one always. Good job kp
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.