Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I'm seeking a table to cut mortise and tenons mostly. The horizontal one by MLCS for under $200 seems to nicely fit the bill. I'll pack my P-C 895 in it. Has anyone used the horizontal setup for cutting M&T's? Woodhaven has a similar looking unit for nearly $300. Thanks for your time!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top