Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
22,526 Posts
Check for a short shank set, they allow you to use a thinner template. But this looks like a pretty standard set and the price is OK. Short shank means that the tube the bit passes through (collar) is less than a quarter inch long. Also, you must get a centering pin or cone (https://www.homedepot.com/p/Bosch-R...zA&gclsrc=ds&dclid=CMqc_9Ks7d0CFfMA-QAdoAoB7w) to make certain the bit is dead centered theough the collar. If it isn't it can affect the size or accuracy of the cut. Centering pins are cheap. Pix below.

Here's a video on how they're set up...
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top