Router Forums banner
1 - 1 of 14 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
A friend gave me a wonderful OLD router and table, belt driven, Montgomery Ward Model 93FD865A. I don't have much routing experience but I've never seen one like this. Anyway, it only came with one router bit, and I am scratching my head figuring out how to adapt the spindle on the router to be able to accept the modern 1/4 inch shaft router bits. I have photos attached of the router assembled, and also disassembled to show the center spindle, which apparently doesn't come off. Help! What do I do?


1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.