Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,308 Posts
Whenever I have a student who wants to 3D carve the entire top of their material I usually have them hot melt glue the material to a larger scrap of plywood which then can either be clamped down or screwed into the spoil board. If the bottom side will be hidden then screws up through the plywood are used rather than hot melt glue.

4D
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top