Wanted! pictures of your router table!

This is my no frills table, still need to add a tension board and run some vacuum lines.

The table is just something I threw together from 2x4 and 3/8" plywood. The top is covered in some laminated 1/4"ply that it had lying around and it was glued in place. The fence is angle iron I had in the stock pile as well as the aluminum mounting plate. I welded two nuts to the fence and ran bolts through to hold the fence after aligning. Its worked very well for what I've asked of it, and I have plans to add much more onto it.

There are 3 holes (third picture) that the router mounts to and hangs under the table. I'll get some pictures of the router actually mounted and post those some time.

This is the router I am using.