Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi

Totally new to routing but want to cut a 2mm wide slot 5mm deep 3mm away from the edge of a 18mm deep piece of mdf sheet. I would also like to cut the same size slot again 3mm from the edge of a 550 mm radius curve

Is this possible and what would I need
Any advise would be appreciated
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top