Router Forums banner
1 - 1 of 1 Posts

·
Marine Engineer
Doug
Joined
·
4,960 Posts
Slower is better, in my humble opinion. The thing to remember is to slow down your feed rate and give the bit time to cut. Your router should not have any problems cutting the full profile, but I still like to raise panels in 2 passes.

Also, feather boards pushing down help you keep the stock firmly on the table, as some panel bits (especially those without back cutters) can tend to try to lift the work up.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top