Router Forums banner
1 - 4 of 17 Posts

· Registered
Joined
·
1,702 Posts
Discussion Starter · #1 ·
My guess is you will know what this is or you will not. They are cheap, they work, what more can you want from a tool.

For 100 points tell us what this tool does or how you use it, and as always the points go to the first one who posts a correct answer.

Good Luck,

Ed
 

Attachments

· Registered
Joined
·
1,702 Posts
Discussion Starter · #4 ·
Billwolley said:
This tool was used to position and hold a rippled spline that was most commonly used in joinery on mitered corners. The rippled spline would be placed inside the hollow tool. The tool would then be placed across the two sections to be joined and you would drive the spline into the wood by hammering down on the sliding bar. The bar would place even pressure on the spline and drive the spline into the wood and flush with the surface.

Bill
Very good! In case your unclear about what Bill is tell you see the attached picture.

Points are on the way

Winner!!!!!!!
 

Attachments

· Registered
Joined
·
1,702 Posts
Discussion Starter · #9 ·
Boricua said:
Wow,

I didn't know these existed. Reible, what I need to know is where can I find this tool? I am actually going to use these fasteners for the frame that I am making for my bathroom mirror and didn't know that there was a tool to hammer these in. I tried these fasteners on a scrap piece of wood and it really sucks just using a hammer if you know what I mean. So where can I get one? I'll check the hardware store. Later....
I saw some of these tools a couple of months ago. Rather then being with the fasteners they were in one of those "drawers".... I don't recall what store I was in but it could have been an Ace. You might want to print the picture to take with you.... I have also seen them in catalogs but don't recall which ones.

I have never tried it myself but recall hearing that you can use a drill press to put them in.... no not as a drill press but as an arbor press, the handle combined with the gears gives you a lot of force.....

Ed
 

· Registered
Joined
·
1,702 Posts
Discussion Starter · #11 ·
Billwolley said:
Thanks for the points. By the way - what do we do with points?

Bill
Some day they said we might get like t-shirts or other good things but well it has been awhile and that's why I don't mind giving mine away cause someday they will be worth something and I have plenty. If you put your points in the "bank" they gain interest, that is what I've been doing and now I get like 4000 points a day in just interest.

To answer your question I collect them and give them away..... that is what I do with them.

Ed
 
1 - 4 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top