"What is it?" #16

1645 Views 3 Replies 2 Participants Last post by NewMontanaWorkshop, Jan 14, 2005

reible

Discussion Starter · Jan 14, 2005

Today you will only see three new "What is it?"'s. (This day being defind as to what my day is.)

Again you can look at the picture under attachments. This first post is the only one to have the picture.

After knowing what you see or paging a catalog to find it..... or using the web to. Be the first one to post the correct answer, the correct answer is determinded by me.

The answer needs to give details not just the name.

All items are sitting on a 8 1/2" x 11" sheet of paper.

For 100 points what is it?

See less See more

Save

1 - 4 of 4 Posts

NewMontanaWorkshop

· #2 · Jan 14, 2005

Single-flute countersink:

Used after pre-drilling for a screw, they cut cleanly and are chatter free. The cone tip assures accurate centering and the cutter design ejects chips rapidly. They can also be used for counterboring as necessary.

Save

reible

Discussion Starter · #3 · Jan 14, 2005

Snowshoe said:
Single-flute countersink:

Used after pre-drilling for a screw, they cut cleanly and are chatter free. The cone tip assures accurate centering and the cutter design ejects chips rapidly. They can also be used for counterboring as necessary.

**********************************************************
WINNER
**********************************************************

You sound like you could sell these! Do you own any or was that from a catalog? How ever you knew it does't matter as you are correct!

100 points are yours

Ed