Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
394 Posts
Discussion Starter · #6 ·
steveo said:
Sometimies I wish I had one of these, used to drill holes of various diameters, diameter too small, just go down one more diameter. Primarily used in a drill press where you have better control of bit and material. Used on thin material only.
steveo
Winner!!!

I didn't specify (I'm new at this :p ) that the proper name 'and' use be included, so your the winner with the description of use.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top