Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
394 Posts
Board Edge Center Gauge:

Simple centering gauge is laid on each side of a board edge and 'twisted' until flush with each edge. The center hole is then used to mark a spot or scribe a line down the edge of the board.

Any size material may be used up to the 'open' width of the gauge.
 

·
Registered
Joined
·
1,702 Posts
Discussion Starter · #5 ·
Snowshoe said:
Board Edge Center Gauge:

Simple centering gauge is laid on each side of a board edge and 'twisted' until flush with each edge. The center hole is then used to mark a spot or scribe a line down the edge of the board.

Any size material may be used up to the 'open' width of the gauge.
That answer will get you the 100 points!

Ed
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top