Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,625 Posts
Hi Mike...

It is an edge guide. In the same orientation as is pictured, unscrew the wing nut, place the slot of the brass colored piece onto the wing nut post and screw wing nut back on. The end of the brass colored piece has a small detention that fits over the shaft of the knurl knob allowing for micro adjustments with the wing loosened.

The bearing would ride on the surface of the edge of the board or piece that you wish to trim or profile. The two long rods slide into your router base and would be secured by screws or thumb screws. Slide them in and out for gross adjustments. The bearing end also allows for adjustment so the bearing rides squarely on the edge of the board...

Hope this helps...Nick
 
  • Like
Reactions: Carrot
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top