Joined
·
1,882 Posts
I use Minwax Oil Modified Polyurethane and spray it on with a HVLP spray gun. I re-finished our kitchen table and it was like a layer of glass... I couldn't believe I did it. The following review is not mine but is written well.
"SPRAY IT"
Review Rating 5 Stars Reviewed on 04/04/2018
Recommended
I have been a furniture maker for 40 years. I have used many products and after seeing another pro use this in a LVHP ( compressor ) spray gun. I was convinced. I use a very inexpensive 30.00 sprayer with a 2.0 tip. The first coats need to be very dry ... also fogged on . 2-3 coats dry and then sand with 320 lightly ..... then and only then can you begin to build coats. You can sand in 30 minutes if you are in the 70+ degree range. It does not load the paper and sands perfectly. No lacquer thinner to buy for clean up. I rinsed everything out ( water ) and then fill the gun cup with water put clamp on the trigger and walk away. I still cannot believe this product is this good ... but it is. I do not know the hardness figures to compare to solvent material .
"SPRAY IT"
Review Rating 5 Stars Reviewed on 04/04/2018
Recommended
I have been a furniture maker for 40 years. I have used many products and after seeing another pro use this in a LVHP ( compressor ) spray gun. I was convinced. I use a very inexpensive 30.00 sprayer with a 2.0 tip. The first coats need to be very dry ... also fogged on . 2-3 coats dry and then sand with 320 lightly ..... then and only then can you begin to build coats. You can sand in 30 minutes if you are in the 70+ degree range. It does not load the paper and sands perfectly. No lacquer thinner to buy for clean up. I rinsed everything out ( water ) and then fill the gun cup with water put clamp on the trigger and walk away. I still cannot believe this product is this good ... but it is. I do not know the hardness figures to compare to solvent material .
