Router Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
842 Posts
Discussion Starter · #1 ·
I'm building a couple of cabinets to go along with my old kitchen cabinets and I'd like to make the doors match but I can't figure out what router bit to use. I just need to make a small radius on the corner. Can you tell me what bit to use?

Thanks,
Bryan
 

Attachments

·
Registered
Joined
·
31,264 Posts
that's a cove bit..
Bryan will you please order several printed router bit catalogs for reference...
 
  • Like
Reactions: bryansong

·
Registered
Joined
·
31,264 Posts
go to router bit manufacturer sites and order them...

some you cam order the book others will let you down load it..
 

·
Registered
Joined
·
842 Posts
Discussion Starter · #5 ·
Thank you Stick, I have placed an order at Rockler for a Freud 1/4"R 1/2 shank bit.

I will say that I had been looking a Google images as well as MLCS for router bit profiles but I wanted someone to tell me for sure what profile to use.
 

·
Registered
Joined
·
966 Posts
A few years ago I attended a local woodworking show and at the Freud booth there were a bunch of catalogues for router bits. I still use it and refer to it regularly. Until this catalogue, I never imagined there were so many different router bits !
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top