Router Forums banner
1 - 1 of 8 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I just finished putting together a cncest 6040. Loaded Mach 3 and have everything except the tool touch set up.
The question I have is what router set up do I use for the 6040 if I use V-carve Pro? The list in vectric does not list a 6040 in any shape or form I have found. The table size it shows is only 12 x24 max.
I am SO lost.
Once I get it all turned on, how do I set up a job even. I have ZERO paperwork or instructions
Thanks in advance,
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.