Router Forums banner
1 - 1 of 1 Posts

5 Posts
I use the PC 7539, it is variable speed, soft start plunge router. It was a little big for the Oak Park table but it fit with the removal of one handle. The important thing with
the selection of the router to be used with large bits like a raised panel bit is the size
of the throat of the router, it should allow at least 2 1/2".

Good luck, Richard Wey
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.