Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Carbide tip bit will work fine. If you just slightly enlarging freehand will be fine, if it's a lot cut it undersize about an 1/8" with a jig saw then use the router bit. If you can't use a jig saw cut it undersize with the router then come back and clean cut it to the line.
If you want it perfect you could make a template, as mentioned above, and tape it in place if there is room.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top